The building plans give a specific order for wiring in the bulkheads. I followed that order. It was difficult to get a bulkhead aligned and tightened the first time. The best technique was to insert a bulkhead loosely and then insert the next bulkhead before going back and aligning and tightening the first. There was a lot of tension in the hull sides that wanted to shoot the bulkheads up so it was important to angle the wires for a downwards pull. The stern was hard to pull together and required pipe clamps and patience. But in the end everything aligned correctly.

First Bulkhead

Second Bulkhead

Third Bulkhead

Fourth Bulkhead


Clamping the Stern

Clamping the Stern

Clamping the Stern

Stern Wired

All Bulkheads Wired In