Build Date: June 2018

Once my 1/4” marine plywood arrived I set to work cutting the pieces for the hull sides, butt blocks, and bulkheads. I did a lot of tedious measuring and re-measuring before cutting the first pieces. And then used those pieces as templates for the rest of the hull sides. Afterwards, I clamped the pieces together and used a belt sander to make them uniform. Same story with the bulkheads. It was hard to cut the holes in the bullheads and end up with a perfect circle, but it was pretty close.

Hull Measurements

Cutting the First Hull Piece

Stern Piece Cut

Laying Out the First Hull Pieces

Copying a Bow Piece

Laying Out Bulkheads

Bulkhead Complete

Cabin Bulkheads Before Cutting Holes

All Parts Cut!

» Next Post